Steps:
1. Open Virtual Network Editor
2. Add Network "VMnet*"
3. Choose "NAT" or "Host only", NOT "Bridged"
4. Check Connect a host virtual adapter to this network
5. Make DHCP unchecked
4. Open Windows Network panel
6. Choose "VMware Network Adapter VMnet*" and your physical network card, right click, choose "Bridge"
7. Wait for a moment, you will see a "Network Bridge" adapter
8. Configure network in VM with static ip, DONE!

QQ截图20150205122907.png

中文(Chinese):http://www.cnblogs.com/brucex/p/4274466.html
- 打開 Workstation 的“編輯”菜單中的“虛擬網絡編輯器”

- 添加網絡“VMnet*”

- 設為“僅主機模式”或者“NAT”都可以

- 勾選“將主機適配器連接到此網絡”

- 去掉勾選“DHCP”服務

- 打開“控制面板\網絡和 Internet\網絡連接”

- 複選中對應的“VMware Network Adapter VMnet*”和物理網卡適配器(如“乙太網”),右擊“橋接”

- 出現“Network Bridge”適配器,橋接成功

- 進入虛擬機,配置網絡,使用靜態IP

- 結束

Felix 發表在 痞客邦 PIXNET 留言(0) 人氣()